Table of Contents
Advertisement
the following potential hazards might
apply:
1.
Contact with exposed saw teeth of
the saw chain (cutting hazards)
2.
Access to the rotating saw chain
(cutting hazards)
3.
Unforeseen, abrupt movement of
the guide bar (cutting hazards)
4.
Flung out of parts from the saw
chain (Cutting / injection hazards)
5.
Flung out of parts of the work
piece
6.
Inhalation of work piece particles
and emissions from the gasoline
engine
7.
Skin contact with the fuel
(gasoline / oil)
8.
Loss of hearing, if no required ear
protection used during work.
GENERAL POWER
TOOL SAFETY
WARNINGS
The term "power tool" in the warnings
refers to your mains-operated (corded)
power tool or battery-operated
(cordless) power tool.
1.
The declared vibration total value
may be used for comparing one tool
3
with another, and may also be used in
a preliminary assessment of exposure.
2.
The vibration emission value
during actual use of the power tool can
differ from the declared value depending
on the ways in which the tool is used
dependent on the following examples
and other variations on how the tool is
used:
3.
To be accurate, an estimation of
exposure level in the actual conditions
of use should also take account of all
parts of the operating cycle such as the
times when the tool is switched off and
when it is running idle but not actually
doing the job. This may significantly
reduce the exposure level over the total
working period.
4.
Do not connect the chain saw to
mains before it is completely
assembled. Always use gloves when
handling the chain.
5.
Remove battery pack from chain
saw before servicing. Severe injury or
death could occur from body contact
with moving chains.
6.
Cutting edges on chains are
sharp. Use protective gloves when
handling chains
Work Area Safety
1.
Keep work area clean and well lit.
Cluttered or dark areas invite
accidents.
Advertisement
Table of Contents
