Table of Contents
Advertisement
Filling Oil Tank:
1.
Set the chainsaw on any suitable
surface with an oil filler cap facing
upward.
2.
Clean the area around the oil filler
cap with a cloth unscrew cap.
3.
Do not remove filter insert during
filling.
4.
Add chain saw oil until the
reservoir is full.
5.
Avoid dirt or debris entering the oil
tank, refit oil filler cap (4) and tighten.
Important: To allow venting of
the oil reservoir, small breather channels
are provided between the oil filler cap
and the strainer, to prevent leakage and
ensure the machine is left in a horizontal
position (oil filler cap (4) uppermost)
when not in use. It is important to use
only the recommended oil to avoid
damage to the chain saw. Never use
17
recycled/old oil. Use of non-approved oil
will invalidate the warranty.
Operation
Switching On and Off
(See fig. A)
Check the voltage and current supply:
The voltage and current supply must
comply with the ratings on the type
plate.
For switching on the machine, press the
lock-off button (3), then fully press the
on/off switch (2) and hold in this
position. The lock-off button (3) can now
be released. For switching off, release
the on/off switch (2).
Filling the Oil Reservoir
(See fig. B)
Check oil level gauge (19) prior to
starting and regularly during operation.
Refill oil when oil level is low. The oil
tank filling will last approx. 16minutes,
depending on sawing intensity and
stops. (Fig. B) Check new replaced
Advertisement
Table of Contents
