Cabletron Systems EMC39-12 User Manual page 22

Chapter 3: Connecting to the Network
Proceed with the following steps to connect the EMC39-12 to a
10BASE-T compliant Ethernet device:
1. Attach a 50-pin feeder cable to the Champ RJ21 connector on the
EMC39-12 as shown in Figure 3-1.
EMC39-12
Figure 3-1 50-Pin Feeder Cable Connection to the EMC39-12
2. Attach the other end of the 50-pin feeder cable to the Champ RJ21
connector on the 10BASE-T compliant Ethernet device.
3. Verify that the Link LED on the 10BASE-T Ethernet device is on and
the applicable TPLNK LED on the EMC39-12 is on. If the LEDs are
off, perform each of the following steps until the LEDs are on:
a. Be sure the 10BASE-T device and the EMC39-12 have power.
b. Examine the cable connection between the EMC39-12 and the
10BASE-T device.
c. Inspect the cable for continuity.
If a Link is not established, contact Cabletron Systems Technical Support.
3-2
Ethernet Media Converter
WITH
12X
LANVIEW
1X
EMC39-12 User's Guide
1854-07