Regulator Hose Assembly - Bayou Classic SP31 Owner's Manual

REGULATOR HOSE ASSEMBLY

WARNING
• The pressure regulator hose assembly supplied with this product must be used.
• Clean and inspect the hose before each use for any evidence of abrasion, wear, cuts or leaks. Hose must
be replaced prior to use if any of these issues are found. Only use manufacturer recommended replacement
assembly.
• Replace regulator hose assembly at least every two years.
• Keep the fuel supply hose away from any heated surface.
• Refer to instructions for connecting regulator hose assembly to LP gas cylinder and burner in this manual.
• The valve on regulator hose assembly controls the flame intensity only, it is not an ON/OFF valve.
• DO NOT attempt to connect to any other fuel supply source such as a natural gas line.
• DO NOT attempt to adjust or repair the regulator. A replacement can be supplied by contacting the
manfacturer.
• DO NO attempt to disassemble the regulator assembly.
REGULATOR HOSE ASSEMBLY
• Use only the regulator hose assembly that is supplied with this appliance.
Clean and inspect the hose before each use of the cooker. If there is evidence
of abrasion, wear, cuts or leaks, the hose must be replaced prior to the cooker
being put into operation. Replace regulator hose assembly at least every two years.
This part can be purchased by contacting www.thebayou.com.
• Refer to instructions for connecting regulator hose assembly to LP gas cylinder
and burner in this manual.
• The valve on regulator hose assembly controls flame intensity only. It is not an ON/OFF valve. Use LP Cylinder Valve
to turn gas ON and OFF.
Your cooker is equipped with a Type-1 connection device
with the following features:
1. The system will not allow gas flow from the cylinder until a
positive connection to the cylinder valve has been made.
NOTE: The cylinder valve must be turned off (clockwise) before any
connection is made or removed.
2. A GAS FLOW LIMITING DEVICE, when activated, restricts the
flow of gas to 10 cubic feet per hour.
NOTE: the flow limiting device is a safety feature that can be activated
when attempting to light cooker. If this occurs, refer to Trouble Shooting
on pages 16 - 17 for proper remedy.
3. After cooking is finished and cylinder valve is turned off; turn the
Regulator Control Knob counter-clockwise to the OFF position.
This will reduce possibility of activating the Gas Flow Limiting Device the next time you light the cooker.
WARNING
Insure the cylinder valve is CLOSED prior to connecting the LP gas cylinder to your cooker. Turn the regulator
control knob to properly close the regulator valve. Read and follow all instructions and warnings on the supply
hose safety tags. Read and follow all warnings in this manual concerning the safe use of LP gas cylinders and
the regulator hose assembly, before connecting cylinder to cooker. Read and follow all warnings on the LP
gas cylinder.
Regulator
Valve
For connection to
LP Gas Cylinder
11
TYPE-1
Connector
Coupling Nut
Brass Orifice
Connector
For connection
to Burner