User Information - V-fit FMTC3 Assembly & User Manual

Your Exercise Monitorhas been specially designed to help you plan and viewyour exercise performance.
NORMAL OPERATING TEMPERATURE
To provide ease of use, there are 3 buttons on your V-fit Exercise Monitor: - SET, MODE and RESET.
Press the MODE button once to move onto the SCAN mode. The display will change approx EVERY 6 SECONDS to show each of the Exercise
Monitor's functions i turn. n o T anu m
The Exercise Monitor's functions are displayed in the following order: - SCAN SPEED, DISTANCE, TIME, ODOMETER, CALORIES and PULSE.
To start the Exercise Monitor, either press the MODE button or start to exercise and the Exercise Monitor will begin to register the various functions.
To reset data stored in any individual function, (except Odometer which requires the removal of the batteries to reset the data) press and hold the RESET
button for more than 3 seconds when you are in each mode. This will enable you to set to zero any previous figures remaining in each individual function.
For the PULSE function, MOISTEN your HANDS before using to ensure a good contact is made on the PULSE SENSOR PADS. Failure to do this may
result in a bad connection and an erratic pulse reading. Refer to the guide in your Assembly and Training Manual for guidance on Pulse Limits.
You can individually set Distance, Time and CALORIES by pressing the SET button in each function followed by the MODE button.
To fit the necessary BATTERIES - (NOT SUPPLIED) to your Exercise Monitor, remove the BATTERY COVER at the REAR of the monitor.
Carefully fit the batteries by fitting between the exposed contacts in the battery compartment. Ensure that batteries are fitted with the '+' / '-' ends
matching the outline on the sticker or in the battery
which is not covered by our guarantee.
Page

User Information

EXERCISE MONITOR USER INSTRUCTIONS
EXERCISE MONITOR FUNCTIONS
SCAN ~ (CHANGING FROM FUNCTION TO FUNCTION)
SPEED ~ (CYCLE SPEED [KM/H])
DISTANCE ~ (EXERCISE DISTANCE [KM])
TIME ~ (COUNT UP [Minutes and Seconds])
ODOMETER ~ (ACCUMULATED TOTAL DISTANCE)
CALORIES ~ (COMPUTED THEORETICAL CALORIE BURN)
PULSE ~ (ACTUAL EXERCISE PULSE RATE)
MONITOR FUNCTION SPECIFICATIONS
SCAN
SPEED
DISTANCE
TIME
ODOMETER
CALORIES
PULSE
MONITOR OPERATING SPECIFICATIONS
POWER SOURCE
STORAGE TEMPERATURE
USING YOUR EXERCISE MONITOR
ally move through the functions in turn, press the MODE button TWICE to select the desired function.
compartment. Failure to fit batteries correctly may result in damage to your Exercise Monitor
PLEASE DISPOSE OF OLD BATTERIES CAREFULLY AND CONSIDERATELY.
BATTERY INSTALLATION