2.6
Start/stop times
Table 3
Start/stop times
Capacity
Typical seek times (ms)
Power-on to ready (sec)
Standby to ready (sec)
2.7
Power Specifications
The drive receives DC power (+5V) through a native SATA power connector (refer to
2.7.1
Power consumption
Power requirements for the drives are listed in the table in
nominal conditions, at 25°C ambient temperature. These power measurements are done with DIPM enabled.
• Spinup current is measured from the time of power-on to the time that the drive spindle reaches operating speed.
• Read/Write current is measured with the heads on track, based on three 64 sector read or write operations every 100 ms.
• The drive supports three idle modes: Performance Idle mode, Active Idle mode and Low Power Idle mode. Refer to Section 2.7.4 for power-
management modes.
Table 4
DC Power Requirements
Power Dissipation
Spinup (max)
Write average
Read average
Idle, low power mode
(1)
Standby
Sleep
1.
Standby power is measured at steady state (after 200ms from transition)
Seagate BarraCuda Product Manual, Rev. F
1-disk models
Typical
2.8
2.5
Table
1-disk models
+5V input average (25° C)
1.70W
1.60W
0.45W
2-disk models
1-disk models
3.3
3.0
Figure
3).
4. Typical power measurements are based on an average of drives tested, under
2-disk models
+5V input average (25° C)
1.00A
1.80W
1.70W
0.50W
0.13W
0.13W
Drive Specifications
2-disk models
Max @ 25°C
3.5
3.0
11