Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Seagate ST2000LM007
Summary of Contents for Seagate ST2000LM007
- Page 1 Mobile HDD 5400 RPM - SATA Product Manual Standard models Self-Encrypting Drive models ST2000LM007 ST2000LM009 ST1000LM035 ST1000LM037 ST500LM030 SED (FIPS 140-2) models ST2000LM010 ST1000LM038 100775165, Rev. D September 2016...
- Page 2 Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. SeaTools and 3D Defense System are either a trademark or registered trademark of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. The FIPS logo is a certification mark of NIST, which does not imply product endorsement by NIST, the U.S., or Canadian governments.
-
Page 3: Table Of Contents
Seagate® Technology Support Services ........ - Page 4 S.M.A.R.T. commands ............... . 34 Seagate Mobile HDD Product Manual, Rev. D...
- Page 5 Example of FIPS tamper evidence labels..............23 Seagate Mobile HDD Product Manual, Rev. D...
-
Page 6: Seagate® Technology Support Services
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate Mobile HDD Product Manual, Rev. D... -
Page 7: Introduction
Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate® Mobile HDD model drives: Standard Standard SED Standard SED models models (FIPS 140-2) models ST2000LM007 ST2000LM009 ST2000LM010 ST1000LM035 ST1000LM037 ST1000LM038 ST500LM030 Previous generations of Seagate Self-Encrypting Drive models were called Full Disk Encryption (FDE) models Note before a differentiation between drive-based encryption and other forms of encryption was necessary. -
Page 8: About The Serial Ata Interface
Register Block. All Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the Serial ATA International Organization: Serial ATA (Revision 2.6). The specification can be downloaded from www.serialata.org. Seagate Mobile HDD Product Manual, Rev. D... -
Page 9: Drive Specifications
Relative humidity 5% to 95% (non-operating) Relative humidity gradient (max) 30% per hour 37.7°C max (operating) Wet bulb temperature 40.0°C max (non-operating) Altitude, operating –304.8 m to 3048 m (–1000 ft to 10,000+ ft) Seagate Mobile HDD Product Manual, Rev. D... -
Page 10: Formatted Capacity
One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. † Seagate does not recommend operating at sustained case temperatures above 60°C. Operating at higher temperatures will reduce useful life of the product. Formatted Capacity... -
Page 11: Physical Organization
(such as track-to-track and average), are expected to meet the noted values. However, due Note to the manner in which these drives are formatted, benchmark tests that include command overhead or measure logical seeks may produce results that vary from these specifications. Seagate Mobile HDD Product Manual, Rev. D... -
Page 12: Start/Stop Times
During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Standby power is measured at steady state (after 200ms from transition) Seagate Mobile HDD Product Manual, Rev. D... - Page 13 Drive Specifications 2.7.1.1 Typical current profiles The typical 5V startup and operation current profile is shown in Figure 1 Figure Figure 1 Typical 1D - 5V Startup and Operation Current Profile Seagate Mobile HDD Product Manual, Rev. D...
- Page 14 Drive Specifications Figure 2 Typical 2D - 5V Startup and Operation Current Profile Seagate Mobile HDD Product Manual, Rev. D...
-
Page 15: Conducted Noise
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to standby mode. In both Idle and standby mode, the drive accepts all commands and returns to active mode when disk access is necessary. Seagate Mobile HDD Product Manual, Rev. D... -
Page 16: Environmental Specifications
-304.8m to 12,192m Altitude (-1000ft to 10,000ft) (-1000ft to 40,000ft) Seagate does not recommend operating at sustained case temperatures above 60°C. Note Operating at higher temperatures will reduce useful life of the product. The recommended storage period: • 1 year under controlled conditions of 34°C 90%RH or less Note •... -
Page 17: Vibration
Test for prominent discrete tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 18: Electromagnetic Immunity
From this page, click on the “Is my Drive under Warranty” link. The following are required to be provided: the drive serial number, model number (or part number) and country of purchase. The system will dis- play the warranty information for the drive. Seagate Mobile HDD Product Manual, Rev. D... -
Page 19: Agency Certification
Information Technology Equipment (ITE). Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. -
Page 20: Environmental Protection
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 21: Configuring And Mounting The Drive
Figure Figure 3 Attaching SATA Cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Mobile HDD drives support latching SATA connectors. Seagate Mobile HDD Product Manual, Rev. D... -
Page 22: Drive Mounting
2X M3 X 0.5-6H 2X (3.000) MOUNTING HOLES: BOTH SIDES 7.000 0.200 BOTH SIDES MIN 3MM FULL THD 3.505+.075-.3X90 (90.600) (4.070) (14.000) BASE (61.720) 4X M3 X 0.5-6H MIN 2.5MM FULL THD 3.505+.075-.3X90 Seagate Mobile HDD Product Manual, Rev. D... - Page 23 0.20 100.35 0.25 (13.430) 69.850 0.250 22.450 16.520 2.499 1.270 7.949 1.270 (90.600) (14.000) BASE 2X M3 X 0.5-6H 2X (3.000) BOTH SIDES 7.000 0.200 MOUNTING HOLES: BOTH SIDES 3.505 +.075 -.3 X90 Seagate Mobile HDD Product Manual, Rev. D...
-
Page 24: About Fips
Figure 6 Example of FIPS tamper evidence labels. For reference only. May not represent actual drive. Note Seagate Mobile HDD Product Manual, Rev. D... -
Page 25: About (Sed) Self-Encrypting Drives
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands: •... -
Page 26: Random Number Generator (Rng)
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1. -
Page 27: Serial Ata (Sata) Interface
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. All used voltage pins (V ) must be terminated. Seagate Mobile HDD Product Manual, Rev. D... -
Page 28: Supported Ata Commands
Set Max Features Password: register as defined to the right. Lock: Unlock: Freeze Lock: Set Max Address Ext Set Multiple Mode S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h S.M.A.R.T. Enable Operations B0h/D8h Seagate Mobile HDD Product Manual, Rev. D... - Page 29 ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Seagate Mobile HDD Product Manual, Rev. D...
-
Page 30: Identify Device Command
Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Number of sectors transferred during a Read Multiple or Write Multiple command xxxx Seagate Mobile HDD Product Manual, Rev. D... - Page 31 Hardware reset value (see description following this table) xxxx Auto acoustic management setting xxxx Stream Min. Request Size 0000 Streaming Transfer Time - DMA 0000 Streaming Access Latency - DMA and PIO 0000 Seagate Mobile HDD Product Manual, Rev. D...
- Page 32 ATA-reserved 0000 Transport major version number 101F 223–254 ATA-reserved 0000 Integrity word xxA5 See the bit descriptions below for words 63, 88 and 93 of the Identify Drive data. (on next page) Note Seagate Mobile HDD Product Manual, Rev. D...
- Page 33 Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Word 93 1 = 80-conductor cable detected, CBLID above VIH 0 = 40-conductor cable detected, CBLID below VIL Seagate Mobile HDD Product Manual, Rev. D...
-
Page 34: Set Features Command
Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above Note Seagate Mobile HDD Product Manual, Rev. D... -
Page 35: Commands
S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Mobile HDD Product Manual, Rev. D... - Page 36 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100775165, Rev. D...
Need help?
Do you have a question about the ST2000LM007 and is the answer not in the manual?
Questions and answers