Bonavita BV1500TD Manual page 9

and the filter basket from the
brewer.
10. For maximum heat retention
place the lid on the carafe shortly
after the brew cycle is complete.
(Fig. E).
11. To dispose of the used filter, dump
it from the filter basket, rinse out
filter basket, and set aside to dry.
12. To pour coffee from the carafe,
depress the lever on the carafe
lid. The lid must be tightened
firmly to allow for one-handed
pouring (Fig. F).
Auto Start Mode – to brew a batch
of coffee at a later time.
1. Set time of day, following
directions in BEFORE FIRST USE
section.
2. Press the PROG button to set
programmed brew start time.
While the display is flashing
adjust the start time with the HR
and MIN buttons, then press the
PROG button again. The PROG
button will be lit when auto start
mode is engaged.
3. Fill the water tank with fresh,
filtered, cold water, and place a
filter and ground coffee into the
filter basket.
4. Your brewer will brew at the start
time you have programmed.
5. Press PROG button each time
you want to brew in the auto start
mode.
6. To deactivate the auto start mode,
press the ON/OFF button twice.
To reactivate the auto start mode,
either adjust the brew start time or
press the PROG button twice.
Optional Pre-infusion Mode – for
brewing freshly roasted coffee.
1. Press and hold the ON/OFF
button for 5 seconds.
2. If a "1" is displayed the pre-
infusion is disabled. A "2"
indicates the pre-infusion mode is
enabled. Press the HR button to
change the value.
3. Press the PROG button to save
the change.
4. Press the ON/OFF button to start
brewing or set the timer for brew
start time mode.
5. The brewer will remain in pre-
infusion mode until the mode
is turned off or the brewer is
unplugged.
6. You can turn off the pre-infusion
mode by pressing the on/off
switch until the light flashes (5
sec.).
7. The am/pm will flash when the
pre-infusion mode is enabled.