Table of Contents
Advertisement
This instruction leaflet belongs to the appliance
and must be kept in a safe place. If changing
owners, the leaflet must be surrendered to the
new owner.
DO ENSURE that the mains lead cannot be
tripped over.
DO NOT operate the radiator with the mains lead
overhanging the fins.
The heater must be on a flat stable surface when
in use.
If the radiator is tipped over, unplug it and allow
it to cool before standing it back up
DO NOT pull the radiator along by the mains lead.
The supply cord should be uncoiled before use.
ELECTRICAL CONNECTION
WARNING THIS APPLIANCE MUST BE EARTHED
If the socket outlets in your home are not of the 13 amp BS1363
type they will not accept the plug connected to this heater,
therefore cut off the plug. When cut off this plug can constitute
a shock hazard if inserted into a socket outlet. It must therefore
be disposed of safely.
IMPORTANT: The wires in this mains lead are coloured in
accordance with the following code:
BLUE:
BROWN:
GREEN & YELLOW:
As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug, proceed
as follows:
Connect the BROWN wire to the terminal marked 'L' or
coloured RED. Connect the BLUE wire to the terminal marked
'N' or coloured BLACK. Note: 'L' or 'N' must not be connected
to the EARTH terminal marked 'E' or ' ' or coloured GREEN
or GREEN AND YELLOW. If in doubt, consult your electrician.
Assembly and Positioning
FITTING THE CASTORS
WARNING The radiator must only be operated
with the wheels and castors fitted and in the
upright position.
NEUTRAL
LIVE
EARTH
The castors must be fitted to the control panel and on
the bracket between the last and second last fin on the
opposite end, as shown in Fig.1.
To fit the castors, turn the radiator upside down on a
carpet or other soft surface to avoid damage
WARNING : THE RADIATOR IS HEAVY – ENSURE
THAT IT IS SUPPORTED TO PREVENT IT FROM
TOPPLING. Ask a second person to help with this if
necessary.
To fit the castors, position the castor plates (A) in
position and secure using the wing bolts (B). there
are guides to ensure the correct positioning and
orientation of the caster plate.
Return the radiator to the correct orientation so it rests
on the castors. The product is now ready for use.
B
A
Fig. 1
Advertisement
Table of Contents
