Safety Features - Dimplex ECR15Ti Quick Start Manual

Dry column heater
Table of Contents

Advertisement

Safety Features

This appliance incorporates a number of safety devices. In
addition to the 'Important Safety Advice' section your attention
is drawn to the following;
Tilt Switch
The tilt switch will prevent the heater from working if it is
accidentally tipped over on its side.
If the radiator is tipped over while it is hot, disconnect the
power and allow it to cool, then stand the radiator back upright.
Reconnect the power - normal operation should be resumed.
Safety Overheat Protection
The heater is fitted with a thermal safety cut-out which will
switch off the heater should it overheat for any reason. If the
cut-out operates it is the result of abnormal overheating. The
appliance should be disconnected from the power supply and
customer services should be contacted for further advice - see
'After Sales Service'.
DO NOT attempt to reuse the product until the fault has been
suitably rectified.
Model Identifier(s):
Heat output
Nominal heat output
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/ room temperature control
With mechanical thermostat room temperature control
Contact details
ECR12(Ti(e))
Pnom
1.2
Pmin
0.4
Pmax,c
1.2
elmax
0.0
elmin
0.0
elSB
0.0
GDHV, Milbrook House, Grange Drive, Hedge End, Southampton, SO30 2DF
Additional
Storage
If the radiator is not required for long periods, for example
during the summer, it should be stored in a dry place and
preferably covered to prevent the accumulation of dirt and
dust. The supply cord should be neatly coiled around the cable
wrap (see Fig. 1) and the plug should be inserted in to the plug
pin holes provided in the cable wrap.
IMPORTANT
The heater must be kept plugged in at the mains to retain the
time and the programmed settings. If unplugged from the
mains, resetting the time and the programmed settings will be
necessary.
Cleaning
WARNING - ALWAYS DISCONNECT THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powder or polish of
any kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove
dust and a damp cloth (not wet) to clean off stains. Be careful
not to allow moisture in to the heater.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
ECR15(Ti(e))
ECR20(Ti(e))
1.5
0.5
1.5
0.0
0.0
0.0
ECR25(Ti(e))
2.0
2.5
0.6
0.8
2.0
2.5
0.0
0.0
0.0
0.0
0.0
0.0
kW
kW
kW
kW
kW
kW
Yes

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecr15Ecr20Ecr20tiEcr20tie

Table of Contents