Cabletron Systems 9C106 Setup And Installation Manual page 27

2. Remove the Fan Module from the protective plastic bag. (Save the bag in the
event the unit must be reshipped.) Observe all precautions to prevent damage
from Electrostatic Discharge (ESD).
3. Examine the Fan Module, carefully checking for damage. If any damage is
noted, DO NOT install the Fan module. Contact Cabletron Systems
immediately.
4. Hold the sides of the Fan Module.
5. Line up the rails on the Fan Module with the tracks on the chassis.
6. Slide the Fan Module into the chassis until it is completely seated.
7. Secure the Fan Module into the chassis by tightening the slotted screws.
8. To remove a Fan Module, perform these steps in reverse.
Fan Tray
Knurled Knobs
Figure 2-4. Installing the Fan module
SmartSwitch 9000-6 Slot Chassis Installation
9C406 FAN
2-9