Table of Contents
Advertisement
Rack Mounting the SmartSwitch 9000-6 Slot Chassis
The chassis can be mounted in a standard 19-inch equipment rack.
If the rack is not secured to the ßoor, it is recommended that the SmartSwitch
9000-6 Slot be installed in the bottom half of the rack. This prevents the rack from
!
being top heavy.
CAUTION
Read the section
following procedure.
Two people may be required to lift the chassis into place.
The chassis is secured with ten bolts, Þve on each side. Using the bolts provided
with the rack, bolt the chassis to the rack, starting with the bottom holes and
working up, as shown in Figure 2-1.
, Installation Requirements,
SmartSwitch 9000-6 Slot Chassis Installation
in this chapter before completing the
2-3
Advertisement
Table of Contents
