Generac Power Systems G0071450 Owner's Manual page 31

4. Open lid and reset emergency stop alarm on con-
trol panel.
5. Set generator set MLCB (generator set disconnect)
to OFF (OPEN).
6. Remove 7.5 amp fuse from control panel.
To turn generator set back ON:
1. Install 7.5 amp fuse in control panel.
2. Verify generator set MLCB (generator set discon-
nect) is OFF (OPEN).
3. Press AUTO button on the control panel.
4. Generator set will start and run. Allow generator
set to run and warm up for a few minutes.
5. Set generator set MLCB (generator set disconnect)
to ON (CLOSED).
6. Close and lock lid.
7. Set main circuit breaker in the distribution panel to
ON (CLOSED).
8. Turn on mains power supply to transfer switch
using means provided (such as a mains MLCB).
The system now operates in automatic mode.
Owner's Manual for 50 Hz Air-Cooled Generator Sets
Operation
25