Hot Surfaces - Generac Power Systems G0071450 Owner's Manual

Hot Surfaces

The enclosure provides protection against
hot surfaces inside the generator set. Hot
surfaces may be present if the generator set
has been operating under a large load. Do
not open the generator set enclosure while
the generator set is running.
The generator set enclosure provides protection against
hot surfaces inside the enclosure. Surfaces which may
be hot while the generator set is operating are identified
in Figure 1-2.
Follow the generator set shutdown procedure in
ting Generator Set Down While Under Load Or
During A Mains Power Outage
enclosure. This allows adequate cooling to reduce the
risk of exposure to hot surfaces.
Owner's Manual for 50 Hz Air-Cooled Generator Sets
ISO000533
Shut-
before opening the
Figure 1-2. Hot Surfaces
Safety Information
006597
9