Universal Laser Systems M-360 Safety, Installation, Operation, And Basic Maintenance Manual page 64

MATERIAL SETTINGS GUIDE
Create more stamps to fill the entire page. They can be the same stamp or different ones. If desired,
output the page to a paper printer for proofreading. Printing out a positive image to a printer is easier to
read and uses less toner or ink than a negative print.
In the laser systems printer driver, use the same settings as the previous example but with only minor
modifications. In the Windows 98 driver, in Rubber Stamp section, click all three options; Add Shoulder,
Print Negative and Print Mirror. In the Windows 2000/XP driver, click on Configure and make sure that
Mirror Page and Invert Page are selected.
Print to the laser system. Position the full sheet of rubber stamp material in the same upper left location
on the engraving table and begin engraving. The driver automatically adds the shoulder, mirrors the
entire page, creates a negative image for engraving, and cuts out the stamps.
Section 5-26