Universal Laser Systems M-360 Safety, Installation, Operation, And Basic Maintenance Manual page 63

1
2
3
4
5
6
7
8
9
Place a sheet of rubber stamp material into the UPPER LEFT CORNER against the rulers, as the
diagram illustrates, and be sure to properly focus on the material. In the ULS Printer Driver, set the
Power, Speed, PPI, and DPI (Image Density) parameters. If you are unsure about which settings to use,
consult the Material Settings section earlier in this chapter. Also, set the page size Width to 11 inches
and the Height to 8.5 inches. In the Windows 98 printer driver, click on Add Shoulder but do not select
Print Negative or Mirror Image. Select No Halftoning and make sure Clipart Mode, Coated Metal Mode,
and Curve Enhancement are turned OFF. In the Windows 2000/XP driver, choose Rubber Stamp, from
the dropdown list in the Print Mode section of the driver, and then click on Configure. Choose the type of
rubber stamp from the Taper Selection dropdown list. Make sure that Invert Page and Mirror Page are
NOT selected, and then click OK. In the Pen Mode section, the black color should be set to RAST and the
red color should be set to VECT.
After making all driver selections, print the graphic to the laser system. Start engraving and watch the
stamp engrave and cut in the correct position on the rubber sheet. The background area, since it is
colored black is being engraved and the letters remain standing up. When the engraving part is done, the
stamp gets cut out along the red cut line due to the stronger settings that were assigned in the driver for
the color red.
Full Sheet Method
The second method is to create a full sheet of rubber stamps and engrave them all at the same time.
First create a stamp as a positive image as shown.
MATERIAL SETTINGS GUIDE
0 1 2 3 4 5
AREA WHERE NEW
STAMP WILL ENGRAVE
PREVIOUSLY
COMPLETED
STAMPS
LASER ENGRAVING TABLE
BLACK FILLED GRAPHIC
Action Sports Equipment
100 Easy Street #117
Plainville, KS 99924
RED CUT LINE .001" THICK
Section 5-25
6 7 8 9 10 11
SHEET OF RUBBER
BLACK FILLED TEXT
12 13
STAMP MATERIAL