Universal Laser Systems M-360 Safety, Installation, Operation, And Basic Maintenance Manual page 17

5) Slowly rotate the laser cartridge making sure
that the alignment plate is centered in the gap of
the alignment fork between the small and large
plates. As you slowly release the weight of the
laser, you should feel it lock (clunk sound) itself
smoothly into place, parallel to the mounting
surface. NEVER FORCE THE LASER INTO
POSITION. If the laser does not install smoothly,
check for obstructions such as pinched wires or
hoses or a binding laser latch. Once installed,
verify that the alignment plate is centered within
the alignment fork.
Checking Beam Alignment
•
Open the top door of the laser system. Locate the power cord and
plug it into the system and your grounded electrical outlet.
International users may need to connect an adapter to the power
cord to be able to plug it into their power source. MAKE SURE
THAT YOU ATTACH THE ADAPTER CORRECTLY TO THE
POWER CORD AND THAT YOUR POWER SOURCE IS
PROPERLY GROUNDED (EARTHED) OTHERWISE SERIOUS
DAMAGE CAN OCCUR TO THE LASER SYSTEM.
•
Place a small piece of masking tape across the 3/4" hole in the focus
carriage (1). Gently rub the tape around the edge of the hole so that
you can see the outline of the hole through the tape (2) and then
close the top door.
•
Power ON the laser system and after the system finishes initializing,
open the top door.
•
Press the X-Y button on the control panel and a red dot will appear on the masking tape (3). The red
dot should appear centered, or close to the center of the hole, within 1/8 inch. If not, remove and re-
install the laser cartridge and try again. If the red dot still does not appear within 1/8" of the center of
the hole, please contact our Service Department.
•
Laser cartridge installation is complete. Power OFF the laser system and remove the masking tape.
INSTALLATION
6) Plug in the power connector (1). Slowly close
the rear cover and making sure that wires or
hoses become pinched when the cover is
closed. Push down on the latches until they
"click".
Section 2-5
2
I
3