Enabling Web Management; Starting And Stopping Enterasys Webview - Enterasys Vertical Horizon VH-2402S Web Management Manual

Enabling Web Management

The HTTP Configuration menu is used to enable or disable the ability to
manage the switch with Web management. The HTTP Server parameter
must be set to ENABLED before Enterasys WebView can be used to
manage the switch. If it is desired to disallow Web management of the
switch, this parameter should be set to DISABLED
1. Starting at the Main Menu of the User Interface, select Management
Setup Menu / Network Configuration / HTTP Configuration.
2. Select HTTP Server, and use the Space bar to toggle between
ENABLED and DISABLED.

Starting and Stopping Enterasys WebView

Do the following to use Enterasys WebView:
1. Start a Java-enabled Web browser from any machine with network
access to the switch. (Preferred browsers include Internet Explorer
4.0 or above, or Netscape Navigator 4.0 or above.)
2. Enter the IP address for the switch you want to manage in the URL
field of the browser.
3. The screen shown below will appear, prompting you to enter the user
name and password for management access.
Use the name for the default administrator (ADMIN), and the
password previously entered in the Setting Up Web Management
section. This will allow read/write access to the switch.
The full application will now launch. A four-frame page will display
with the product graphic located in the upper right hand frame.
4. To stop Enterasys WebView, close the Web browser application.
9033821
Using Web-Based Management 5