Axis M5525-E User Manual page 13

AXIS M5525-E PTZ Network Camera
Additional settings
1. Go to Settings > System > Events > Action rules and add an action rule.
2. Type a name for the action rule.
3. From the list of triggers, select Applications and then select AXIS Video Motion Detection (VMD).
4. From the list of actions, select PTZ Control and then select Preset Position.
5. Select the preset position you want the camera to go to.
6. Click Ok.
Record video when a PIR detector senses motion
This example explains how to connect an Axis PIR detector to the camera, and set up the camera to start recording when the
detector senses motion.
Required hardware
• 3-wire cable (ground, power, I/O)
• Axis PIR detector
NO NOTICE NO TICE TICE
Disconnect the camera from power before connecting the wires. Reconnect to power after all connections are done.
Connect the wires to the camera's I/O connector
Note
For information on the I/O connector, see Connectors on page 21.
1. Connect the ground wire to pin 1 (GND/-).
2. Connect the power wire to pin 2 (12V DC output).
3. Connect the I/O wire to pin 3 (I/O input).
Connect the wires to the PIR detector's I/O connector
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera's webpage
1. Go to Settings > System > I/O ports.
2. Select Input in the Port 1 drop-down list.
3. Give the input module a descriptive name.
4. To make the PIR detector send a signal to the camera when it senses motion, select Closed circuit in the drop-down list.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create an action rule in
the camera's webpage.
13