D) Environmental Protection; Installation Of Your Machine; A) Before Plugging In; B) The Electrical Connection - Brandt SM2006B Instruction Manual

d) Environmental Protection

It is good to know that microwaves cause a simple heat phenomenon inside food and that they
are not harmful to health.
At the end of its life this product must not be discarded with household waste. It must be
taken to a recycling centre or to your dealer. This makes it possible to avoid consequences
resulting from inappropriate disposal that are harmful to health and the environment, and to
recycle materials to save energy and significant resources.
A logo appears on the product reminding you not to discard it with household waste. For
further information, contact your council offices or the shop where you bought this product.
Your machine also contains several recyclable materials. It is therefore marked by this logo to
show you that used machines should not be mixed with other waste.
The recycling of machines organised by your manufacturer will therefore be performed in the
best conditions, in compliance with European Directive 2002/96/EC concerning electrical or
electronic equipment waste. Contact your Town Hall or your dealer to find out where the points
nearest to your home for the collection of used machines are. Thank you for helping to protect
the environment.

2) INSTALLATION OF YOUR MACHINE

a) Before Plugging In
Caution:
Check that your machine has not been damaged during transport (door or seals distorted, etc.).
If you notice any damage whatsoever contact your dealer before use.

b) The Electrical Connection

Check that:
- the power of the installation is sufficient.
- the mains leads are in good condition.
- the diameter of the wires complies with the installation rules.
- your installation is fitted with 20 ampere heat protection.
If in doubt please consult your electrician.
The electrical connection must be carried out before placing the machine in its final position.
Electrical safety must be ensured by a correct connection. During maintenance operations the
machine must be unplugged from the mains and the fuses must be cut off or removed.
The machine must be connected with a standardised power cable with three 1.5 mm²
conductors (1 live + 1 neutral + 1 earth) which must be connected to the 220-240V 50Hz single
phase mains with a standardised electric socket CEI 60083 fitted with two pins and one earth in
compliance with the installation rules in force.
26