Table of Contents
Advertisement
o
6-6
6-6
SERVICE
ptIonAL
Do NOT use Thread Sealer on Drain Fitting!
1. Tee is factory-installed. If adjustment is
necessary, tighten factory-installed tee no
more than ¼ turn. Do not overtighten
threads, or the drain fitting or tee may
become damaged.
2. Do NOT use thread sealer on ABS drain
fitting. If sealer is used the ABS drain
fitting may crack or leak! (If a tee needs
to be installed it should be tightened no
more than 4 turns.) Do not
overtighten threads.
3. Dry fit the supplied water
seal / trap to ensure
approximately
/
1
2
clearance from the bottom
of the trap to the floor as
shown.
P/N 0539221_T
D
p
rIp
IpIng
/
1
Approx.
in. Clearance to Floor
2
in. of
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
(Drain Fitting)
Factory Installed (four turns)
Factory-Installed
Tee Fitting
NOTE: It may be necessary to rotate water
seal (trap) inside the tee a few degrees to ensure
clearance at two locations. There must be
clearance 1) between the bottom of the water
seal and the floor, and 2) between the top of
the water seal outlet and the bottom of the
merchandiser. Do not over-rotate or gravity
seal may be compromised. Always rotate trap
bottom toward merchandiser support rail.
Rotate Water Seal
towards back of
Merchandiser if required
Advertisement
Table of Contents
