Changing Channels If Interference Is Heard - 3M C1025 Operating Instructions Manual

Special Instructions for System Manager
Changing Channels
if Interference is
Heard
18
The C1025 system is capable of operating on any one of eight different
channels. If messages etc. from a different transmitter are heard in the
headset or monitor speaker, or if you are told that your store's messages
are being heard elsewhere, interference is occurring. You can correct
either type of interference by changing the base station operating channel.
To do this:
1. Pull outward on the right side of the base station half-cover and then
lift and remove the cover. See Figure 16.
2. With the base station turned on, press and release the Channel Select
switch once. (This advances the system to the next channel.) One of
the red indicators (1-8) will light, indicating the newly selected
channel.
When two systems are used in a cross-lane application, both base stations
must be set to the same channel, but different lane settings
Figure 16.
Figure 17.
Note
Model C1025
.
© 3M 2006