Cadillac 2007 DTS Owner's Manual page 268

®
AudioPilot : If your vehicle has the Bose
Premium audio, the system has AudioPilot
compensation technology.
®
To use AudioPilot press the Automatic Volume
Control screen button to access the AudioPilot
menu and then press the ON screen button.
®
AudioPilot automatically adjusts the volume level
of the audio so that it always sounds the same.
The feature is most effective at lower volume
settings where background noise can be louder
than the audio. At high volume settings there might
be little or no change in the audio level. In some
cases where the noise level changes quickly,
you can hear the audio level changing. This
is normal. For more information on AudioPilot
visit www.bose.com.
To activate AudioPilot
1. Set the radio volume to the desired level.
2. Press the MENU button to display the radio
setup menu.
3. Press the pushbutton located under the AUTO
VOLUM label on the radio display.
4. Press the ON or OFF button to turn this
feature on or off.
268
®
®
®
, do the following steps:
Finding a Station
noise
BAND: Press this button to switch between AM,
FM, or XM™ (if equipped). The selection displays.
®
a
(Tune): Turn this knob to select radio
stations.
© ¨
SEEK
to go to the next or to the previous station and
stay there.
To scan stations, press and hold either SEEK
arrow for three seconds until a beep sounds. The
radio goes to a station, plays for a few seconds,
then goes to the next station. Press either
®
,
SEEK arrow again to stop scanning.
The radio only seeks and scans stations with a
strong signal that are in the selected band.
: Press the right or left SEEK arrow