Starting And Operating Your Vehicle; New Vehicle Break-In - Cadillac 2007 DTS Owner's Manual

To program the new key do the following:
1. Verify that the new key has a
2. Insert the original, already programmed, key
in the ignition and start the engine. If the
engine will not start, see your dealer
for service.
3. After the engine has started, turn the key to
OFF, and remove the key.
4. Insert the new key to be programmed and
turn it to the RUN position within five seconds
of removing the original key.
5. The security light will turn off once the key
has been programmed.
6. Repeat Steps 1 through 5 if additional keys
are to be programmed.
If you are driving and the security light comes on
and stays on, you may be able to restart your
engine. Your PASS-Key
may not be working properly and must be serviced
by your dealer.
If you lose or damage your PASS-Key
see your dealer or a locksmith who can service
®
PASS-Key III+ to have a new key made.
1
stamped on it.
®
III+ system, however,
®
III+ key,
Starting and Operating
Your Vehicle

New Vehicle Break-In

Notice: Your vehicle does not need an
elaborate break-in. But it will perform better in
the long run if you follow these guidelines:
•
Do not drive at any one constant speed, fast
or slow, for the first 500 miles (805 km).
Do not make full-throttle starts. Avoid
downshifting to brake, or slow, the vehicle.
•
Avoid making hard stops for the first
200 miles (322 km) or so. During this time
your new brake linings are not yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every time
you get new brake linings.
•
Do not tow a trailer during break-in.
See Towing a Trailer on page 336 for the
trailer towing capabilities of your vehicle
and more information.
Following break-in, engine speed and load can
be gradually increased.
113