Enterasys 2E42-27 Appendix page 5

Table B-1 Screen Field Descriptions (Cont'd)
Use this field...
Reboot After
Download
(Toggle)
TFTP Gateway
IP Addr
(Modifiable)
Download
Server IP
(Modifiable)
Download File
Name
(Modifiable)
Last Image
Server IP
(Read-Only)
Last Image File
Name
(Read-Only)
PN 9033215
FLASH Download Configuration Screen
To...
Set the SmartSwitch device so it will either reboot
or not reboot after completing the download of an
image. This field toggles between YES and NO,
when the Download Method field is set to
RUNTIME.
If YES is selected, the device reboots after the
download is completed. If NO is selected, the
device continues using the existing firmware
image and stores the new firmware image in
FLASH memory. The next time the SmartSwitch
device is reset or powered-up, the device boots
from FLASH memory using the new image.
When the Download Method field is set to
DOWNLOAD CONFIG, the setting defaults to
YES and cannot be changed. In UPLOAD
CONFIG, the setting defaults to NO and cannot be
changed.
Enter the IP address of the TFTP gateway server
defined on the General Configuration screen in the
local management supplement.
Select the IP address of the TFTP server to be used
for the download or upload.
Select the complete TFTP server path and file
name of the new image or configuration file.
See the IP address of the server used for the
previous download or upload.
See the complete path and file name of the last
downloaded image.
B-5