Table of Contents
Advertisement
Operating The Product
WARNING: FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN
INJURY AND/OR DAMAGE.
Manual Controls
The manual controls are located behind the stove door. Open the stove door to access the
manual controls. (Fig 2)
is the on/standby button. Press it once to turn on the product. Press it again to turn off the
product. When turned on a 'beep' will sound and the digital display will show
the current room temperature. The display will then turn off. The fuelbed will light up. Be careful
not to look directly into the fuelbed as the LED lights are very bright. It will take a approximatly
45 seconds before the flame effect starts.
is the Mode button.
Press it once and you will be in the
the
and
buttons you can turn the heat on at the LOW or HIGH setting and turn the heat
OFF. You will hear two 'beeps' for LOW heat setting, three 'beeps' for HIGH heat setting and one
'beep' when the heat is turned off.
Press it a second time and you will be in the temperature set mode
the current room temperature and then the set point temperature. Using the
you can adjust the set point temperature up and down. Note: if the set point temperature is below
the room temperature the heat function will not operate. The temperature range is from 15-35°C
Press it a third time and you will be in the Fire mode. The display will show
current fire effect setting. There are six fire settings. Using the
the height of the flame effect.
Press M
Display
Once
Twice
Three times
Remote control
The remote control is supplied with a battery already in place. Simply pull on the clear plastic tab
on the back of the remote control to enable the battery.
is the on/standby button. Press it once to turn on the product. Press it again to turn off
•
the product. When turned on you will hear on 'beep' and the digital display will show
followed by displaying the current room temperature. The display will then turn off. The main
LED lights will activate. Be careful not to look directly into the LED's. These are very bright.
Although the main lights operate immediately it will take a further 45 seconds before the flame
effect starts.
• Press
once to activate
If you continue to press this button you will cycle through the LOW and HIGH heat settings.
You will heat two 'beeps' for LOW heat setting and three 'beeps' for HIGH heat setting.
• Press
once to turn off the heat. You will hear one 'beep'
options. The display will show the current setting. Using
Function
Controls the fan heater
Thermostat
Flame intensity
heat setting. Press it again to activate
. The display will show
and
buttons you can adjust
Press + or -
Off
Low
From 15 °C
From F1 (low)
followed by
and
buttons
followed by the
High
To 35 °C
To F6 (high)
heat setting.
5
Advertisement
Table of Contents
