Midea TempMaker Series Technical Manual page 137

MCAC-UTSM-2014-03
the last page will be displayed. In the setting mode, every time when pressing the key, if it is
in the temperature regulation mode, the set temperature will decrease by 1° C (or 2° C) until
the lowest allowed set temperature. If it is in the timing startup/shutdown time setting mode,
select the upper-level set time, if no time is set, 0.0 will be displayed, if hold down the key,
the upper-level data will be selected consecutively. The specific change mode is as follows:
11) MODE: In setting operation mode, press this key to set the operation.
In other display mode, press this key to enter the setting mode. By default, it is
single-machine setting, and the first in-service air conditioner is displayed.
12) FAN: In setting operation mode, press this key to set the fan of the indoor unit of the air
conditioner to run in the following picture:
13) TIME ON/TIME OFF: In setting operation mode, press them to set the timing startup of air
conditioner. Press them again to exit the timing setting, and restore the normal temperature
regulation operation mode.
14) SWING: In the setting operation mode, press this key to enable or disable the swing function.
If all currently selected air conditioner have no swing function, no effect will result after
pressing the key.
15) RESET: Anytime when the RESET key is pressed, the centralized controller will reset. The
R410A 380~415V 3Ph 50Hz TempMaker Series Split AC
136