Midea TempMaker Series Technical Manual page 123

MCAC-UTSM-2014-03
3) Set the operating mode
Press the mode button
mode will circle as follow:
Notes: When the controller has been set to cool only, then there is no HEAT mode.
4) Fan speed setting
Under COOL, HEAT and FAN modes, press the fan speed button
setting.
After each fan speed button press will circle as follow:
Notes: Under AUTO and DRY modes the fan speed is not adjustable and the default fan speed is auto.
5) Temperature setting
Under AUTO, COOL, DRY, HEAT modes, press the temperature setting buttons
to set the temperature, the adjusting range is 17º C~30 º C (or 62 º F~88 º F).
Notes: The setting temperature cannot be adjusted under fan mode.
6) Timer on and timer off setting
Press the timer/clock setting button
will display
Press the buttons
each press
than 10 hours, each press
setting is 24 hours.
After finish adjusting the timer on setting, press the button
confirm and exit the timer on setting.
to set the operating mode, after each button press the operating
and .
and to adjust the timer. If the timer setting is less than 10 hours,
or will increase or decrease 0.5 hour. When the timer setting is more
or
R410A 380~415V 3Ph 50Hz TempMaker Series Split AC
, then enter into the timer on setting status, and screen
will increase or decrease 1 hour, the maximum timer
can adjust the fan speed
and
or wait for 5 seconds to
122