Checking The Network Settings - Viessmann Vitoconnect 100 Installation And Service Instructions For Contractors

Commissioning
Display and controls
LED System functions
–
Flashes yellow.
Pulsates yellow.
Flashes red.
Pulsates red.
Flashes green.
LED , and
All are illuminated white.
All are illuminated yellow.
Note
Flashing: LED 0.5 s on and 0.5 s off
Pulsating: LED 0.1 s on and 0.9 s off

Checking the network settings

Have the following settings on the WLAN router
checked, and if necessary adjusted, by an IT expert:
Dynamic IP addressing must be set.
■
Port 80 and port 443 must be enabled for outgoing
■
connections.
Registering the user and setting up the heating system
With ViCare app
1. Download and install the ViCare app from the App
Store or Play Store.
Note
If an Apple iPad is being used, limit the app search
to "iPhone only".
2. Start the ViCare app and tap on "Create new
account".
3. Scan the QR code or enter the "manufacturing
data" and "ID".
Note
For the QR code, "manufacturing data" and "ID"
see the label on the Vitoconnect 100.
Vitoconnect 100 OPTO1
Manufacturing data
ID:
MAC addr.:
WPA2:
www.viessmann.com/vitoconnect
Fig. 5
14
(cont.)
Maintenance mode (no data transfer), see page 17
Registration mode active (access point)
Fault at the control unit of the heat source
Access point mode fault, see page 16
A new Vitoconnect 100 firmware is being installed.
!
Please note
Take care not to damage the Vitoconnect.
Never disconnect the Vitoconnect 100 from the power supply during firmware
installation.
The Vitoconnect 100 starts.
The Vitoconnect 100 has been reset to the factory setting and can be commissioned
again.
4. Set up the WLAN
Android: Connection is automatically established
with WLAN "Vitoconnect"
iOS: Close the ViCare app an call up the
■
WLAN settings of the smartphone.
■ Connect the "Vitoconnect" via WLAN.
■ Insert WPA2 password from the clip-
board. The WPA2 password is auto-
matically placed on the clipboard. If
not, see the label on the Vitoconnect.
■ Switch back to the ViCare app.
5. Follow the instructions in the app.
■ Set up the home network.
Enter location or allow ViCare app access to the
■
location.
Enter personal data.
■
■ Accept the data protection agreement and terms
of use.
The Vitoconnect 100 and ViCare app are set up.