Checking The Network Settings - Viessmann VITOCONNECT 100 Installation And Service Instructions Manual

Commissioning
Display and controls
LED System functions
–
Flashes yellow.
Pulsates yellow.
Flashes red.
Pulsates red.
Flashes green.
LEDs , and
All illuminated white.
All illuminated yellow.
Note
Flashing: LED 0.5 s on and 0.5 s off
Pulsating: LED 0.1 s on and 0.9 s off

Checking the network settings

Have the following settings on the WLAN router
checked, and if necessary adjusted, by an IT expert:
Dynamic IP addressing must be set.
■
Port 80 and port 443 must be enabled for outgoing
■
connections.
Registering the user and setting up the heating system
With ViCare app
1. Download the ViCare app from the app store or
play store and install.
Note
If using an Apple iPad, limit the app search to
"iPhone only".
2. Start the ViCare app and tap on "Create a new
account".
3. Scan the QR code or enter the "manufacturing
data" and "ID".
Note
For the QR code, "manufacturing data" and "ID",
see sticker on the Vitoconnect 100.
Vitoconnect 100 OPTO1
Manufacturing data
ID:
MAC addr.:
WPA2:
www.viessmann.com/vitoconnect
Fig. 5
14
(cont.)
Maintenance mode (no data transfer), see page 17
Registration mode active (access point)
Fault at the control unit of the heat generator
Fault, access point mode, see page 16
A new Vitoconnect 100 firmware is being installed.
!
Please note
Do not damage Vitoconnect.
Never disconnect the Vitoconnect 100 from the mains during firmware instal-
lation.
Vitoconnect 100 is starting up.
The Vitoconnect 100 has been reset to the factory setting and can be recommis-
sioned.
4. Setting up the WLAN
Android: Automatic connection with WLAN "Vito-
connect"
iOS: Close the ViCare app and call up the
■
WLAN settings of the smartphone.
■ Connect with WLAN "Vitoconnect".
■ Insert WPA2 password from the clip-
board. The WPA2 password is auto-
matically available on the clipboard. If
not, see sticker on the Vitoconnect.
■ Change back to ViCare app.
5. Follow the instructions in the app.
■ Set up the home network.
Enter location or allow ViCare app access to the
■
location.
Enter personal data.
■
■ Accept data protection agreement and terms of
use.
The Vitoconnect 100 and ViCare app are set up.