Installation Location - Viessmann Vitoconnect 100 Installation And Service Instructions For Contractors

Installation sequence
Sequence overview
Sequence
Installation
1 Check system requirements.
2 Fit wall mounting bracket for Vitoconnect 100.
3 Connect Vitoconnect 100 to heat source.
4 Insert Vitoconnect 100 into wall mounting bracket.
5 Connect power supply.
Commissioning
6 Check network settings.
7 Register user and set up heating system.
Operation with ViCare app
■
Operation with Vitotrol Plus app
■

Installation location

Fig. 2 Sample illustration with wall mounted boiler
To ensure a good WLAN connection, keep the dis-
A
tance between the Vitoconnect 100 and the WLAN
router as short as possible.
Range
The range of WLAN connections may be reduced by
walls, ceilings and interior fixtures. These weaken the
WLAN signal and can cause poor reception.
10
Installation type: wall mounting
■
■
■
Note
A When selecting the installation site, bear in mind the
length of the connecting cables (standard delivery).
Connecting cables/leads
Connecting lead Optolink/USB for con-
necting the Vitoconnect 100 to the boiler
control unit
>0.3 m
Plug-in power supply unit with power ca-
ble
Responsibility
Heating contractor/IT expert
Heating contractor
Heating contractor
Heating contractor
Heating contractor
IT expert
Heating contractor/system user
Distance to heat source: minimum 0.3 m
Standard socket 230 V/50 Hz, max. 1 m lateral dis-
tance to installation site
Internet access with adequate WLAN signal
Note
The WLAN signal strength can be increased with
commercially available WLAN repeaters.
Page
7
11
12
11
12
14
14
Length
3 m
1 m