Contents In Package - Genesis GDP805P Operator's Manual

UNPACKING AND CONTENT
IMPOrTANT:
mass production techniques, it is
unlikely the tool is faulty or that a
part is missing. If you find anything
wrong, do not operate the tool until
the parts have been replaced or the
fault has been rectified. Failure to do
so could result in serious personal
injury.

CONTENTS IN PACKAGE:

(FIG 2)
Item Description
A Head Assembly
B Spindle feed Handles 3
C 1/2" Chuck
D Table Assembly
E Column
f Base
G Chuck Key
H Bolts and Washers
I Allen Wrenches
Operator's Manual (not shown) 1
WArNING:
missing or damaged, do not attempt
to assemble the saw, plug in power
cord or turn the switch on until
the missing or damaged parts are
replaced.
ASSEMBLY
WArNING:
is switched off and unplugged from the power
source before adjusting, adding accessories, or
checking a function on the tool.
ATTACHING THE COLUMN TO THE BASE
(FIG 3)
1. Set the base (f) on the level, flat floor.
2. Place the column tube (E) on the base (f), align the three
holes in the column support with the holes in the base.
3. Install a set of bolt and washers (H) in each column support
hole and tighten with the wrench.
INSTALLING THE TABLE ASSEMBLY
(FIG 3)
1. Loosen the table lock handle (6).
2. Slide the table assembly (D) down onto the column (E).
3. Position the table assembly (D) in the same direction as the base.
4. Tighten the table lock handle (6).
Due to modern
QTY
1
1
1
1
1
1
3 Sets
2
If any parts are
Always be sure that the tool
C
D
G
FIG 2
D
F
FIG 3
A
E
B
F
I
H
6
E
H
7