Understanding The Hardware; Hardware Installation; Ip Address Configuration - EnGenius ECB-8610 User Manual

11a/b/g Wireless Multi-Client Bridge/AP/WDS

2 Understanding the Hardware

2.1 Hardware Installation

1. Place the unit in an appropriate place after conducting a site survey.
2. Plug one end of the Ethernet cable into the RJ-45 port of the device and another
end into your PC/Notebook.
3. Insert the DC-inlet of the power adapter into the port labeled "DC-IN" and the
other end into the power socket on the wall.
This diagram depicts the hardware configuration
PC

2.2 IP Address Configuration

This device can be configured as a Bridge/Router or Access Point. The default IP
address of the device is 192.168.1.1 (Client Bridge mode), 192.168.1.2 (Access
Point mode). In order to log into this device, you must first configure the TCP/IP
settings of your PC/Notebook.
1. In the control panel, double click Network Connections and then double click on
the connection of your Network Interface Card (NIC). You will then see the
following screen.
Ethernet
Bridge/AP
Power Outlet
AC/DC cable
Version 1.0
9