Table of Contents
Advertisement
Using the remote control cursor
Use the remote control to operate your computer during presentations for greater flexibility.
1.
Before using the remote control to replace your cursor, fix one end of the USB cable
to the projector Mini USB port and the other end to the PC or notebook computer.
See
"Connect to the computer"
2.
Change the input signal to D-Sub or HDMI via PC source.
3.
To use the software displayed on the connected computer (such as Microsoft
PowerPoint), go to the previous or next page by pressing the previous page/next
page button.
Remote control effective range
There are infra-red (IR) remote control sensors located at the front and back of the
projector. Hold the remote control and maintain a perpendicular angle within 30 degrees
with the IR remote control sensor to achieve normal remote control functions. The distance
between the remote control and the sensor should not exceed 8 meters (about 26 feet).
Do not place any obstruction in front of the IR sensor on the projector as this may block
the IR beam.
Note
● When an intense light source such as sunlight or fluorescent light is used to illuminate the remote
sensor, the remote control may not work.
● Operate the remote control where you can see the remote sensor.
● Do not shake or drop the remote control.
● Store the remote control in a cool, dry place.
● Do not spill water on the remote control or place moist objects on it.
● Do not disassemble the remote control.
for details.
10
Advertisement
Table of Contents
