Safety Instructions - Venini VCG64 User Manual

Safety Instructions

Safety When Installation
DO NOT USE OR STORE FLAMMABLE
MATERIALS IN THE APPLIANCE STORAGE
DRAWER OR NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY
OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
WHERE THIS APPLIANCE IS INSTALLED IN
MARINE CRAFT OR CARAVANS, IT SHALL
NOT BE USED AS A SPACE HEATER.
This hotplate must be installed in accordance
with:
AS 5601 - Gas Installations (for Australia) –
current edition
NZS 5261 – Code of Practice for the Installation
of Gas Burning Appliances and Equipment (for
New Zealand) This standard may not be now
current!!
Local gas fitting regulations
AS/NZS 3000 – Electrical Installations (Wiring
Rules)
Building codes
Any other relevant statutory regulations.
Check the gas type label on the underside of the
hotplate, adjacent to the gas connection to
ensure it corresponds to the installation gas
supply. If in doubt contact the supply authority.
Disposing Of The Device
When disposing of the device, do not bring it to regular municipal waste containers. Instead, bring
it to electrical and electronic waste recycling and reuse center. A relevant label has been put on the
device, its instructions manual, or the package. The device has been manufactured of recyclable
material. By bringing old device to recycling collection center, you show that you care about nature.
Ask your local environmental care authority for information on location of such facilities.
The power supply cord (supplied) must not touch
against any hot surfaces and must be placed so
that its temperature does not exceed 75 degrees
at any point along its length.
After connecting to gas, check for leaks using
soapy solution, never a naked flame.
Where a flexible hose assembly is used, ensure
it is approved to AS/NZS 1869, Class B 10mm
diameter and no more than 1.0metre in length.
Any hose assembly used must be restrained
from accidental contact with the flue outlet of an
under bench oven.
How To Avoid Damage To The Appliance
Do not use the cooking zones with empty
cookware or without cookware.
The ventilation gap of 5mm between the worktop
and front of the unit underneath it must not be
covered.
DO NOT MODIFY THIS APPLIANCE.
Safety When Cleaning
For cleaning, the appliance must be switched off
and cooled down.
For safety reasons, the cleaning of the appliance
with steam jet or high pressure cleaning
equipment is not permitted.
3