Download Print this page

Tekkeon EXPLORER myPower ALL MP3450 Manual page 4

Universal battery

Advertisement

Step 1:
The EXPLORER terminals battery must be inserted
before you connect the MP3450.
Step 2:
Connect the adapter C to the output cord if
charging an EXPLORER 300, EXPLORER 500 or
EXPLORER 700 (see Connection Overview).
Connect the adapter B to the output cord if
charging an EXPLORER 110.
Step 3:
Connect the other end of the output cord to the
DC OUT on the MP3450.
The output voltage will automatically be set to 5V
(red LED) to protect the device that will be
connected.
Step 4:
With the voltage lock in the unlocked position
(switched right to VOLTAGE), set the voltage
output to the input voltage of the EXPLORER
terminal.
EXPLORER 110 = 14V
EXPLORER 300 and EXPLORER 500 = 16V
EXPLORER 700 = 19V
To do this, press the voltage selector until the
correct voltage indicator (LED) turns ON.
Step 5:
Slide the voltage lock to the locked position
(switch left to LOCK). This will prevent
accidentally selecting a different output voltage
while charging the EXPLORER terminal or other
devices.
Please refer to Figure 4.
Step 6:
Connect the other end of the output cord to the DC
input of the EXPLORER terminal.
Step 7:
On the EXPLORER 300, EXPLORER 500 and
EXPLORER 700 the green LED left to the display
is constantly lit as long as the battery is charging
(Figure 5). When the battery is fully charged, the
green LED is turned off.
If the EXPLORER terminal is switched on, the
green LED will be flashing every 2 seconds when
fully charged.
On the EXPLORER 110 the battery indicator in
the EXPLORER ISDN Handset will show four bars
when the battery is between 60 to 80% full (Figure
6).
Step 8:
When the EXPLORER battery or other devices is
charged unplug the MP3450.
You can preserve power by following below guidelines:
Disconnect the MP3450 when the EXPLORER battery is approximately 80 to 90% charged.
Point the EXPLORER antenna carefully to obtain best possible signal strength.
Upgrade the EXPLORER terminal firmware to latest software release.
Accredited Solution
EXPLORER – myPower ALL MP3450 Universal Battery Page 4/5
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Figure 5.
Figure 6.

Advertisement

loading

This manual is also suitable for:

Explorer mypower all mp3450-10