Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Tekkeon myPower All plus P3450-10
Summary of Contents for Tekkeon myPower All plus P3450-10
- Page 1 MP3450i/MP3450-10 User Guide...
-
Page 3: Table Of Contents
USER GUIDE Contents Overview......................2 Getting Started ....................2 Unpacking myPower ALL Plus ................2 Getting to Know myPower ALL Plus ..............3 Storing myPower ALL Plus ................3 Charging myPower ALL Plus ................4 Charging with a Power Adapter ..............4 Charging with a Solar Panel ................4 Using myPower ALL Plus..................5 Select/Connect the Adapter Tip................6 Connect the Power Output Cord ..............6... -
Page 4: Overview
Overview myPower ALL Plus MP3450i is a rugged, high-capacity lithium polymer battery for use with ™ instruments or industrial equipment. This universal battery provides instant power for devices that require between 5V and 19V, and is targeted to users who prefer a fixed voltage that will not be reset upon disconnection of the connected device. -
Page 5: Getting To Know Mypower All Plus
Getting to Know myPower ALL Plus Capacity Level Indicators Capacity Level Button Voltage Setting (Dip Switch) Charging/Indicator DC OUT For connection to device ON/OFF switch DC IN For connection to power adapter MP3450i MP3450-10 Battery port for connection to MP3450-10 Storing myPower ALL Plus Lithium polymer batteries must be used consistently for maximum performance. -
Page 6: Charging Mypower All Plus
Charging myPower ALL Plus To charge MP3450i, you can use either the included power adapter or a solar panel. The steps to charge with either of these devices are described in this section. Charging with a Power Adapter myPower ALL Plus will charge in four hours when completely empty. The green CHARGE indicator will turn on after the battery is 80% charged. -
Page 7: Using Mypower All Plus
The 3-Pin Input port is designed to allow charging by smaller solar panels (lower than 25W), and requires an optional Smart 3-Pin Adapter available from Tekkeon. To use the solar panel with this port, the solar panel must have a minimum open circuit voltage of 15V. However, there is no minimum output current requirement from the solar panel. -
Page 8: Select/Connect The Adapter Tip
Center Negative WARNING: myPower ALL Plus supports Center Positive polarity only. If your device has a Center Negative polarity, do not power the device with myPower ALL Plus; contact support@tekkeon.com for assistance. 3. Connect the adapter tip to the power output cord (but not the device). -
Page 9: Adjust The Voltage Level
Adjust the Voltage Level 1. Locate the voltage specification for your portable device. This can be found on the device power adapter label or device specification label which typically is found on the bottom of the unit. (If available, use the voltage specification shown on the power adapter.) 2. - Page 10 VOLTAGE CHART...
-
Page 11: Connect The Portable Device
Connect the Portable Device 1. Connect the adapter tip into the power jack on the portable device. 2. Slide the ON/OFF switch to ON to turn on myPower ALL Plus. 3. Turn on the portable device and use it as you would normally. While connected, myPower ALL Plus will power and charge your device. -
Page 12: Obtaining Adapters
You can obtain most adapters through the web site, or by contacting Tekkeon by phone at 888-787-5888 or 1-714-832-1266. If available through Tekkeon, the adapter will be sent to you for a nominal fee. -
Page 13: Troubleshooting
If not, try another adapter. 5. Verify that the polarity of the device power jack is Center Positive. If the polarity is Center Negative, please contact support@tekkeon.com for assistance. 6. Check that the output voltage for your portable device matches or is just below the output voltage set on myPower ALL Plus. -
Page 14: Limited Warranty
The product enclosed herein is warranted to be free of operational defects for a period of one year from the date of purchase. In the event of a defect in operation during the warranty period Tekkeon, Inc. will replace the defective product when the owner returns all product contents. The limited warranty will be considered void if the unit is tampered with, subject to misuse, negligence or accidental damage, has been improperly serviced, or if the security seal is removed. -
Page 15: Customer Support
Customer support for myPower ALL Plus is available at: Tekkeon, Inc. c/o myPower ALL Plus 3002 Dow Avenue, #134 Tustin, CA 92780 888-787-5888 / 714-832-1266 Tekkeon, Inc. must issue a Return Merchandise Authorization (RMA) number for all exchanges or refunds. www.tekkeon.com... - Page 16 © 2008 Tekkeon, Inc. Rev A All Rights Reserved myPower is a trademark ™ of Tekkeon, Inc. Cut loose. Stay loose.