Crosley XGBS400 Owner's Manual page 27

Troubleshooting Tips ... Before you call for service
Problem
Oven light does not
work
Oven will not self-clean
Excessive smoking
during clean cycle
Oven not clean after a
clean cycle
Strong "burning" or
"oily" odor emitting
from the vent
Excessive smoking
during broiling
Oven latch will not
open.
"LOCK DOOR" flashes
in the display
"F— and a number
or letter" flash in the
display
Clock flashes due to a
power outage
Lock Controls or
Control Lockout feature
is activated
Surface Burners do not
light
49-2000228 Rev. 0
Possible Cause
Light bulb is loose or defective.
The temperature is too high to set a
self-clean operation.
Oven controls improperly set.
Excessive soil or grease.
Oven controls improperly set.
Oven was heavily soiled.
This is normal in a new oven and will
disappear in time.
Food too close to burner element.
The temperature inside the oven has
not dropped below the unlocking
temperature.
The self-clean or steam-clean cycle
has been selected but the door is not
locked.
You have a function error code.
Power outage or surge
Plug on range is not completely
inserted in the electrical outlet.
Gas supply not connected or turned on. See the Installation Instructions that came with your range.
A fuse in your home may be blown or
the circuit breaker tripped.
Burner parts not replaced correctly.
Burner slots near the electrode, or the
round lighter port on the oval burner,
may be clogged.
Food residue on electrode
What To Do
Tighten or replace bulb. See the Maintenance section for
instructions on how to replace the bulb.
Allow the oven to cool.
See the Cleaning the Oven section.
Press the Cancel/Off pad. Allow the oven to cool below
the unlocking temperature. Wipe the excess soil and reset
the clean cycle.
See the Cleaning the Oven section.
Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for a
longer period of time.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Cleaning the Oven section.
This is temporary.
Lower the rack position of the food.
Press the Cancel/Off pad. Allow the oven to cool below
the unlocking temperature.
Lock the oven door.
Press the Cancel/Off pad. Allow the oven to cool for one
hour. Put the oven back into operation. If the function
code repeats, disconnect all power to the oven for at least
30 seconds and then reconnect power. If the function
error code repeats again, call for service.
Reset the clock. If the oven was in use, you must reset
it by pressing the Cancel/Off pad, setting the clock and
resetting any cooking function.
If LOC ON appears in the display, the range control is
locked. Turn this feature off to use the range. See the
Oven Controls section.
Make sure electrical plug is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the circuit breaker.
See the Care and Cleaning section.
Remove the burners and clean them. Check the electrode
area for burned-on food or grease. See the Care and
Cleaning section.
Lightly polish flat tip of electrode with nail file or
sandpaper until shiny.
27