Ricoh Pro 8300 Series Cip Training page 10

CIP Training Pro 8300 series
Throughput
Paper path and clearing misfeeds
Procedure for removing jammed paper
1. Remove the jammed paper by following the procedures that are displayed on the control
panel.
When [Previous] or [Next] is displayed, press [Next] after completing a procedure.
2. When the jammed paper is removed, restore the machine to the original state.
Multiple aper misfeed locations may be indicated at the same time. When this happens, check all the areas
indicated.
If there is no misfed paper in the area you check first, see the other areas that are indicated.
If coated paper frequently becomes jammed and causes "U" to appear, contact your service representative.
If a paper misfeed occurs in Rb1 - Rb5, check whether any paper has been output on top of the paper press of the
finisher shift tray. If there is paper on top of the paper press, remove the paper, and then remove the misfed
paper from inside the finisher.
When paper cannot be transferred to the post-processing side by turning the knob D1 as instructed on the screen,
see the position of the letter in the figure and turn the knob D1 in reverse direction (clockwise) to send the paper
back to the drawer unit, and then remove the paper.
After C is displayed and the drawer unit is pulled out to remove the jammed paper, check that there is no toner
searing on the location indicated in the figure. If toner smear is left, wipe off the toner with a clean and dry
cloth.