Maintenance - Genesis GMS1015LC Operator's Manual

When cutting crown molding in this method, the bottom of the molding goes against the fence. Think of the table
of the saw being the ceiling, and the fence as being the wall. Angled "flats" on back of molding must rest squarely
on the fence and base of the saw.
The following instructions are for cutting crown molding for a 90° corner.
Left Side:
1) Miter RIGHT at 45°
2) Save RIGHT End of Cut
Right Side
1) Miter LEfT at 45°
2) Save LEfT End of Cut
CUTTING WARPED WORKPIECES
note:
It is recommended that you do not cut warped material.
Sometimes you have no choice but to use a piece of warped material. To cut warped workpieces, make sure it is
positioned on the miter saw table with the convex side against the fence. DO NOT place the concave side of the
work piece against the miter saw fence; when it is cut it will collapse near the completion of the cut, pinching the
blade.
wArning:
never place the concave portion of bowed or warped material against the fence.

MAintenAnCe

wArning:
before making any adjustments or during set-up prior to cutting. Failure to disconnect or
unplug the machine may cause accidental starting, resulting in serious personal injury.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. use clean cloths to remove dirt, dust, oil, grease, etc.
wArning:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these
types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool
using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication
18
INSIDE CORNER
to avoid possible serious personal injury and possible kickback,
Always be sure the miter saw is disconnected from the power source
do not at any time let brake fluids, gasoline, petroleum-based
10" Compound Miter Saw
Operator's Manual
OUTSIDE CORNER
Left Side
1) Miter LEfT at 45°
2) Save Right End of Cut
Right Side
1) Miter RIGHT at 45°
2) Save LEfT End of Cut
GMS1015LC
.