Transmit Ss Digits; Receive Ss Digits; Menu Functions - Textron Greenlee Communications DataScout 10G User Manual

74

Menu Functions

Transmit SS digits:

Configure the test set for Selective Signaling (SS) by selecting 4-Wire Signaling under
the 2/4 Wire mode pull down menu (upper left). Use the LoopStart/DID pull down to
select SS. Ensure SS Dial mode is from the pull down menu to the right of the phone#
box. Enter 2 or 3 digits in the phone# box using the pop up keyboard. Press the Dial
button to transmit the digits out the Tx of the 4-Wire port. For testing purposes the test
set allows any number of digits to be dialed!

Receive SS digits:

Configure the test set for Selective Signaling (SS) by selecting 4-Wire Signaling under
the 2/4 Wire pull down menu (upper left). Use the LoopStart/DID pull down to select
SS. The test set is now ready to receive SS digits on the 4-Wire RX port and will be
displayed in the receive digit window. Up to 20 digits can be received then you must
exit and re-enter SS mode to capture additional digits.
Menu Functions
Under the Menu button (left of power button) you will find Sys-Info, E&M mode and
Save Results. The Sys-info displays the unit software/firmware revision along with the
installed options. The set jack to EM configures the E&M SB/SG signals to the T1-B
port.
Save Results takes a screen shot and saves to the internal memory. Use a mini USB
cable to retrieve the stored results or Office7 on test set to view results saved.