Technical And Legal Information - Mac allister MTSP800A Manual

MTSP800A by MAC ALLISTER
Technical data
Voltage:230-240V~50Hz
Rated input:800W, S2:10min
Protection class: I
Degree of protection: IP20
No load speed:2950min -1
Carbide saw blade:Ø200 x 30 x 2,4mm
Thickness of riving knife:2,2mm
Bevel angle range:0 -45º
Table size:505 x 335mm
Cutting height max. 90°:45mm
Cutting height max. 45°:27mm
Connector for dust extractor:dia. 24mm
Weight:11kg
Noise and Vibration Data
A weighted sound pressure KpA :.........96.6dB(A)
Uncertainty KpA :...................................3dB
A weighted sound power KwA :.............109.6dB(A)
Uncertainty K
Vibration level:.......................................2.5 m/s
Uncertainty K:.......................................1.5m/s
The declared vibration total value has been measured in accordance with a
standard test method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment
of exposure.WARNING: The vibration emission during actual use of the power
tool can differ from the declared total value depending on the ways in which the
tool is used. The need to identify safety measures and to protect the operator are
based on an estimation of exposure in the actual conditions of use (taking account
of all parts of the operating cycle, such as the times the tool is switched off, when it
is running idle, in addition to trigger time).
Load factor:
A load factor of S2 10 min(temporary duty)means that you may operate the
motor continuously at its nominal power level (800W) for no longer than the
time stipulated on the specifications label (10minutes ON period). If you fail to
observe this time limit the motor will overheat. During the OFF period the motor
will cool again to its starting temperature.
04
wA :..................................3dB
Technical and legal
information
2
2