Trouble Shooting; Recycling And Disposal - Mac allister MTSP800A Manual

Trouble shooting

Suspected malfunctions are often due to causes that the user can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
Problem
1. Product does
not start
2. Product does not
reach full power
3. Unsatisfactory
result

Recycling and disposal

22
MTSP800A by MAC ALLISTER
2.1 Extension cord not
suitable for operation
with this product
2.2 Power source (e.g.
generator) has too low
voltage
2.3 Air vents are
blocked
3.1 Accessory not
suitable for work piece
material
3.2 riving knife not
aligned
WARNING! Only perform the steps described within
these instructions! All further inspection, maintenance
and repair work must be performed by an authorised
service centre or a similarly qualified specialist if you
cannot solve the problem yourself!
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or local store for recycling advice.
Possible cause
1.1 Not connected to
power supply
1.2 Power cord or plug
is defective
1.3 Other electrical
defect to the product
with blade.
Trouble shooting
Solution
1.1. Connect to power
supply
1.2. Check by a specialist
electrician.
1.3. Check by a specialist
electrician
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3.1. Use proper accessory
3.2 Check by a speciallist
electrician.