Table of Contents
Advertisement
Contents
5-3 How to Make Measurements
6. Maintenance
6-1 Battery Replacement
6-2 Fuse Replacement
6-3 Calibration Procedure
7. Using the Stand
!
WARNING
PLEASE READ THIS INSTRUCTION MANUAL
CAREFULLY
Misuse and/or abuse of this instruction cannot be prevented by
any printed word and may cause injury and/or equipment
damage.
Please follow all these instructions and measurement
procedures faithfully, and adhere to all standard industrial
safety rules and practices.
The multimeter shall be used in over voltage category II !
!
-2-
3
Do not attempt to measure a voltage while the test leads are
4
plugged into the current input terminals.
5
This would place a short circuit across the voltage since
current ranges have a low impedance. Always check the
5
position of the test leads before making measurements.
5
6
8
7. Using the Tilt Stand
8
Use the tilt stand on the back side to prop up the meter or to
8
hold the test leads.
10
Propping up the Meter
12
This meter has the tilt-stand on the back side to help provide a
13
better viewing angle.
13
To use the tilt-stand, just open it away from the meter and set
14
it on a flat surface.
15
Holding the Test Leads
The tilt-stand equips the two holes at the center to hold the test
leads while you are not doing any measurements.
Simply set each red & black lead in each hole.
CAUTION
-15-
Advertisement
Table of Contents
