Resetting The Lamp Time - JVC DLA-RS3000 Instructions Manual

Resetting the Lamp Time

Reset the lamp time when you have replaced the lamp.
It provides an estimated timing for lamp replacement
Resetting the lamp time from the menu
screen
Press the [MENU] button to display
1
the menu
Select "Function"""Lamp Reset"
2
from the menu
Trigger
Off Timer
ECO Mode
Network
Remote Code
High Altitude Mode
Lamp Reset
Factory Reset
Software Update
On the "Reset Lamp Time?" screen,
3
select "Yes" and press the [OK] button
The lamp time is reset to zero.
0
Reset Lamp Time?
Yes
66
Off
Off
Off
A
Off
No
Resetting the lamp time using the remote
control
Insert the power plug into the power
1
outlet
Make sure that you operate the
remote control in the Standby mode
2
(the power plug is inserted into the
outlet, but the power is not turned on)
Press the keys according to the sequence of the
0
numbers in the illustration.
Make sure that you press a button within two
0
seconds after the last button is pressed.
Press the last button for at least two seconds.
C
D
Press for 2 seconds or
longer
The "LIGHT" indicator and "STANDBY/ON"
0
indicator blink alternately for three seconds.
After that, the unit switches to the Standby
mode.
MEMO
Reset the lamp time only when you have replaced the
0
lamp.
If the lamp time is reset while a lamp is in use, you may
lose track of the timing for replacing the lamp. Doing
so may result in using the lamp beyond the estimated
limit, thereby causing lamp blowout.
B
A