JVC DLA-RS3000 Instructions Manual page 85

Warning display
You can tell the details of a warning from the (repeated) displays of the "WARNING" and "LIGHT" indicators. The
"STANDBY/ON" indicator will light up or appear blinking according to the operation mode of the projector unit. (Please
refer to ""Operation mode display"P. 84".)
The Warning mode is activated once the message is displayed. Projection is interrupted, and the cooling fan is turned
on for about 60 seconds.
The power cannot be turned on again while cooling is in progress. Check the following after cooling is complete.
Indicator Status
WARNING LIGHT
WARNING WARNING LIGHT
(Red) *
WARNING WARNING LIGHT LIGHT
(Red) (Orange)
WARNING WARNING RN LIGHT LIGHT
(Red) (Orange)
WARNING LIGHT
If the Warning mode is activated again, wait for the cooling fan to stop, followed by pulling out the power plug from the
outlet.
Request for repair at your authorized dealer or a nearby service center.
(*) If the scheduled time for lamp replacement is exceeded, the indicator may light up.
Blinking
Frequency
STANDBY/ON
x2
x3
STANDBY/ON
x4
Mode Display
x1
x2
STANDBY/ON
x3
Mode Display
x4
x1
x2
STANDBY/ON
x3
Mode Display
x3
STANDBY/ON ANDBY/O
(Green)
Description
Cooling fan stopped abnormally
Internal temperature is
abnormally high
External temperature is too high
DD board occurs error
Motor board occurs error
CPU board occurs error
Power board occurs error
Lamp does not light up and unit
is unable to project
Lamp goes out during projection
When the lamp cover is removed
The remote control code differs
between this unit and the remote
control
Check and Countermeasure
Check that nothing is
0
blocking the air inlets.
Check that the external
0
temperature is normal.
Countermeasure: Leave the unit
unoperated until it cools down.
After that, turn on the power
again.
Check that the lamp unit and
0
lamp cover are correctly
installed.
Countermeasure: Turn on the
power again.
Set the remote control code for
this unit and the remote control
correctly.(P. 62)
85