Setting The Oscilloscope To A Known Starting Condition - Agilent Technologies 90000 X Series User Manual

2
Using the Oscilloscope

Setting the Oscilloscope to a Known Starting Condition

You can set up the oscilloscope for many different kinds of complex
measurements.
Figure 14 Setup Control Keys
• To automatically configure the oscilloscope for the current input
• To reset the oscilloscope to its default setup, press the [Default Setup]
• If you use the [Default Setup] key with the graphical interface enabled,
Save the Current Oscilloscope Configuration
N O T E
Before using [Default Setup], you may want to save the current oscilloscope configuration
for later use. See the online help (described in chapter 3) for instructions on saving and
recalling setups, and for information on the exact configuration that is set when you press
[Default Setup].
36
signal(s), press the [Auto Scale] key or select Control > Autoscale from the
menu bar.
key or choose Control > Default Setup.
you can choose Control > Undo Default Setup to return the oscilloscope to
its original configuration.
Agilent Infiniium 90000 X-Series Oscilloscopes User's Guide