Operations And Adjustments - Brave BRPFC112HEB Owner's Manual

D. INSTALLATION OF OPTIONAL HITCHES
1. When a long tongue is needed, remove the tongue pivot angles and spacer from the tongue
assembly and attach to the tongue extension. See figure 4. Slip the tongue in between the
two flats on the tongue extension and secure with 1/2" x 3-1/2" hex head bolts, lock washers,
and nuts provided.
2. When a second mower is pulled behind the first mower in tandem, then the rear hitch
assembly can be installed on the rear cross brace tube. See figure 4. Remove the four 1/2" x
3-1/2" bolts from the rear hitch assembly and position the rear hitch in the desired location on
the cross brace tube. Insert the four 1/2" x 3-1/2" bolts from the bottom up and place the
clamping flat on the top. Secure the bolts with the lock washers and the nuts. Tighten down
appropriately to prevent unwanted loosening.
Note: The long tongue assembly (Part # 900136) and rear hitch assembly (Part # 900137)
must be ordered separately.
Tongue Pivot Angle
Figure 4: Long Tongue Assembly and Rear Hitch Assembly
This safety alert symbol is used to indicate safety instructions. Follow
these instructions to avoid personal injury and/or property damage. Read
and follow all instructions in this manual and the included engine manual.
WARNING: Do not allow anyone to operate this equipment who has not fully read and
comprehended the safety manual and who has not been properly trained in the safe
operation of the equipment.
WARNING: Operator should be familiar with all functions of the unit.
BRPFC112HE, REV B
Spacer
Long Tongue Extension
Short Tongue

OPERATIONS AND ADJUSTMENTS

Clamping
Flat
Rear Hitch Assembly
Attach to Rear
Cross Brace Tube
8 REV 3/20