Brave BRPFC112HEB Owner's Manual page 12

Adjust the mower as follows:
1. Pull the mower on to a smooth, level surface.
2. Adjust the mower evenly from side to side by measuring to the ground from the lower edge of
the mower deck. The desired height will be the distance from the ground to the outside lower
edge of the mower deck plus 5/16". The mower blade cutting edge is 5/16" above the outside
lower edge of the mower deck.
Note: If the height adjust cranks do not turn easily, the pivot bolts holding the carrier arm
assemblies and height adjust screw may be too tight. Loosen the pivot bolts slightly to
allow easier pivoting. Care should be taken not to loosen the pivot bolts too much or
excess wear and flexing may occur. Greasing the threads may also allow greater ease
in adjustment.
Note: To mow at a 2" cutting height or below, set the anti-scalp wheels in the top hole. To
mow above a 2" cutting height, set the anti-scalp wheels in the bottom hole.
Mower Blade
Lower Edge
of Deck
Smooth Surface
The adjustment crank may unturn due to vibration. This will allow the mower's cutting height to
change. The crank can be secured by folding it down between the adjustment nut tube and the upper
pivot support. See Figure 8.
BRPFC112HE, REV B
Adjust Anti-Scalp Wheels
Under Deck to the Upper or
Lower Cutting Range
Measure the Distance
and Add 5/16" to get
Cutting height
Figure 7: Adjusting Wing Mower Cutting Height
5/16"
12
Height Adjust Screw
Cutting Height
REV 3/20