Brave BRPFC112HEB Owner's Manual page 16

H. MOWER BLADE REMOVAL, BALANCING & INSTALLATION
CAUTION: Sharp blades can cause bodily injury if not handled properly.
When removing the blade, it is recommended that a block of wood be placed between the blade
and the underside of the mower deck. This will allow the removal of the blade without the need to
hold the blade by hand.
CAUTION: Always balance the mower blades each time they are sharpened.
Out of balance mower blades cause excess vibrations which lead to premature bearing failures,
bolts coming loose, and overall deterioration of the wing mowers.
CAUTION: Always properly tighten the blade bolts to the specified torque. Failure to do so
can lead to unwanted loosening of the blade and damage to the blade holding saddle.
The Model BRPFC112HE uses Part # (202136) blade bolt. This particular hex head bolt is a 1/2"
– 20NF x 1.00" long, grade 5 and its proper torque is 85 ft-lbs.
To ease in the blade installation process, use the same block of wood and method used during
the removal of the blades.
BRPFC112HE, REV B
Initial Spring Length 15/16"
Running Spring Length 1-1/8" to 1-1/4"
Figure 9: Belt Pattern and Spring Adjustment
Front
16
Engine
REV 3/20